Activated Alumina

Jan 24, 2022

Appearance of activated alumina: the activated alumina is a white spherical porous particle with uniform particle size, smooth surface, high mechanical strength, strong moisture absorption, does not swell or crack after water absorption, remains intact, non-toxic, odorless, insoluble in water and ethanol, and has strong adsorption for fluorine. It is mainly used to remove fluorine from drinking water in high fluorine areas.


Activated alumina has selective adsorption ability for gas, water vapor and water of some liquids. After the adsorption is saturated, it can be revived by heating at about 175-315 ℃ to remove water. Adsorption and resurrection can be carried out many times. In addition to being used as desiccant, it can also absorb the steam of lubricating oil from polluted oxygen, hydrogen, carbon dioxide, natural gas, etc. It can be used as catalyst, catalyst support and chromatographic analysis support.


Under certain operating conditions and regeneration conditions, the drying depth of activated alumina is up to the dew point temperature below - 70 ℃. [application of activated alumina]: This product can be used as defluorination agent for high fluorine drinking water (large defluorination capacity), defluorination agent for circulating alkanes in Alkylbenzene production, deacidification regeneration agent for transformer oil, oxygen production industry, textile industry Gas drying in electronic industry, drying of automatic instrument air, desiccant and purifying agent in chemical fertilizer, petrochemical drying and other industries (dew point up to - 40 ℃), and pressure swing adsorption dew point up to - 55 ℃ in air separation industry. It is an efficient desiccant for deep drying of trace water. It is very suitable for non thermal regeneration device.


Introduction to activated alumina for fluoride removal: China's hygienic code for drinking water stipulates that the content of fluoride shall not exceed 1.0mg/l. Raw water with high fluoride is often alkaline, and the pH value is often greater than 7.5.


Fluoride removal methods are roughly divided into the following:


(1) Adsorption filtration method;


(2) Membrane method;


(3) Flocculation sedimentation method;


(4) Ion exchange method.


Main factors affecting the adsorption performance of activated alumina:


(1) Particle size: the smaller the particle size, the higher the adsorption capacity, but the smaller the particle size, the lower the particle strength, affecting its service life.


(2) Raw water pH value: when the pH value is greater than 5, the lower the pH value, the higher the adsorption capacity of activated alumina.


(3) Initial fluorine concentration of raw water: the higher the initial fluorine concentration, the larger the adsorption capacity.


(4) Alkalinity of raw water: the concentration of bicarbonate in raw water is high, and the adsorption capacity will be reduced.


(5) Chloride ion and sulfate ion.


(6) Effect of arsenic: activated alumina can adsorb arsenic in water. The accumulation of arsenic on activated alumina reduces the adsorption capacity of fluorine ions, and it is difficult to elute arsenic ions during regeneration.


How to regenerate activated alumina: sodium hydroxide solution or aluminum sulfate solution can be used as the regenerator.


The solution concentration of sodium hydroxide regenerant is 0.75% - 1%. The consumption of sodium hydroxide can be calculated according to 8-10g solid sodium hydroxide required for removing 1g fluoride, and the amount of regeneration solution is 3-6 times the volume of filter material. The solution concentration of aluminum sulfate regenerant is 2-3%. The consumption of aluminum sulfate can be calculated according to 60-80g solid aluminum sulfate for each 1g fluoride removal.