Factors Influencing The Preparation Of Aluminum Hydroxide
Jan 16, 2023
1. The effect of temperature.
Previous studies have shown that the effect of temperature on the growth rate follows the Arrhenius relation. That is, with the increase of temperature, the growth rate of crystal nuclei will also increase, and the number of particles formed by the hydrolysis of alcohol and brine will increase in unit time, and the particle size will be finer. However, the possibility of forming large grains increases because the number of grains is too large and fast, they collide with each other and agglomerate together. At the same time, due to the increase of the hydrolysis temperature, the supersaturation of the solution decreases, the growth rate of the crystal slows down, and the hydrolysis time is prolonged, so that the particle size of aluminum hydroxide grows up. On the contrary, if the temperature is too low, it will affect the growth rate of the crystal core, which is also obviously unfavorable to the formation of finer particles. Experiments showed that when the temperature was controlled at 65-68 ℃, the pH of the end point of the alcoholization reaction was about 8, and the AI (OH) was obtained. The purity is as high as 99. 95%, the particle size is 0.lgm, especially the effect of isopropyl alcohol is better. At the same time, in order to recover organic solvents, so the temperature is more strictly controlled in the distillation, for this, we choose ethanol as the alcoholizing agent, the time is 2 hours, further test the effect of temperature on particle size, the appropriate temperature is beneficial to the formation of fine particle size.
In this experiment, the factors affecting the particle size of aluminum hydroxide, in addition to the above mentioned, there are ammonia way and its dosage, water quality parameters, etc., do not do a detailed analysis here. At the same time, it is found that the impurities in the product Al (OH) are SiOz and MgO. Among them, SiO2 is mainly brought by anhydrous aluminum chloride, and MgO is mainly brought by water. Therefore, it is more beneficial to improve the quality of raw materials to obtain high-purity products.
2. The effect of time
The mellow time of this experiment is controlled in some aspects about 2 hours is better. It is generally accepted that the length of time will affect the extent of the alcoholization reaction. If the time is too short, it may lead to the end of the alcoholization reaction. On the contrary, too long time is unfavorable to the whole experimental process. At the same time, too short time will also cause uneven particle size distribution, which is due to the increase of the average particle size caused by the different solubility of the small and large particles. On the contrary, if the time is too long, the particles will grow large and not easily form ultrafine structures. Therefore, we also chose ethanol as an alcoholizing agent at a temperature of about 65 ° C to further test the effect of time on the particle size, and the appropriate time is beneficial to the formation of fine particles.
In this experiment, the factors affecting the particle size of aluminum hydroxide, in addition to the above mentioned, there are ammonia way and its dosage, water quality parameters, etc., do not do a detailed analysis here. At the same time, it is found that the impurities in Al (OH) product are SiOz and MgO with high content (as shown in Table 2), among which SiO2 is mainly brought by anhydrous aluminum chloride, and MgO is mainly brought by water. Therefore, it is more beneficial to improve the quality of raw materials to obtain high-purity products.
(1) The experimental results showed that the ultrafine and high-purity Al (OH) was prepared by fermentation; It is feasible, and the process conditions and process flow are determined.
(2) The type of alcoholizing agent is the main factor affecting the particle size of aluminum hydroxide. At the same time, time and temperature also have an important effect on the alcoholization reaction, so the preparation of ultra-fine and ultra-pure aluminum hydroxide should be considered comprehensively.
(3) The particle size of aluminum hydroxide prepared by different alcohols is not the same. The effect of isopropanol as an alcoholizing agent is better, but the operation process of the alcoholization reaction is more complex and difficult to control, which needs to be further studied.
(4) Aluminum hydroxide powder with a purity of more than 99. 95% and a particle size of 0. 4um can be obtained according to the method.


