Precipitation Method And Chemical Reaction Process Of Aluminum Hydroxide
Feb 10, 2023
Alumina is produced from bauxite by Bayer process of high temperature leaching of concentrated alkali to obtain concentrated solution of sodium aluminate. Al in Bayer solution is in the form of [Al (OH) 4] -ligand ion, which is unstable and precipitated by hydrolysis to aluminum hydroxide. The reaction is as follows:

The precipitated aluminum hydroxide may be crystalline or colloidal, depending on the conditions of precipitation, including mother liquor composition, temperature and the presence or absence of crystalline seeds. Typical Bayer solution contains Al2O380kg/m3, Na2O/Al2O3 ratio (refers to molar ratio, the same below) between 1.5 ~ 2.5, simple dilution or cooling can only get colloidal aluminum hydroxide, difficult to separate and wash. In practice, crystal seeds are added to help crystal separation, which is commonly called "seed separation". The practice is to take the newly generated 5-150μm alumina hydroxide crystals in the previous cycle as crystal seeds, greatly excessive into the new crystallization cycle, cooling and slowly stirring for about 4d, to obtain coarse-grained alumina hydroxide crystals. In the initial stage of precipitation, the crystallization rate is proportional to the seed surface area. Effective agitation is necessary, otherwise fine seeds tend to coalesce and reduce the crystallization rate. About 70% aluminum can be crystallized by stirring at 25 ~ 35℃ for 36h. Certain components such as dissolved iron, vanadium and calcium salts have a negative effect on crystallization and are often referred to as inhibitors or neutrals. These inhibitors should be limited to prescribed low levels to ensure the necessary crystallization rate. The precipitated aluminum hydroxide settles to the bottom of the tank and is calcined into aluminum oxide products after filtration and washing. The mother liquor was evaporated and concentrated to a density of 1.45kg·m-3, then returned to leach.
Another way to crystallize aluminum hydroxide from a concentrated solution of sodium aluminate is to neutralize the excess base by passing carbon dioxide, conventionally known as "carbon fraction", usually at 70℃. The associated neutralization reaction is as follows:





